APEX II Compsee with APEX Program Generator, problem getting information from bar codes into database.?

APEX II Compsee with APEX Program Generator, problem getting information from bar codes into database.?

I am an IT person for a smaller company. They have me doing literally everything to do with electronics/computer repair/software/networking/programming you name it I’m on it pretty much. I have no idea about anything to do with bar code scanners. We have a APEX II Compsee and are using APEX Program Generator to upload the bar codes to the computer. This program is suppose to put the new information in a set database after it uploads the bar codes.

The problem is that when the program uploads, it looks like it does everything correct, but the information that it was suppose to gather is no where to be found. Any suggestions to fix this would be very sweet. Thanks.

Tags: , , , , , , , , , ,

Under Forum

1 Comment for APEX II Compsee with APEX Program Generator, problem getting information from bar codes into database.?

  • 1. ?  |  February 15th, 2011 at 8:35 am

    At this web link you can pull down the manual for the Apex II program generator…

    http://www.compseemfg.com/Products/Apex2/Ap2-ProdSupport.htm

    with the generator running and the application open ..
    click application then click parameters you will find the file name and where it is being saved to as will as the file type. once the generator completes this process it has completed it’s operation.

Leave a Comment for APEX II Compsee with APEX Program Generator, problem getting information from bar codes into database.?

You must be logged in to post a comment.

Trackback this post  |  Subscribe to the comments via RSS Feed

Categories