How do I adjust alignment settings on a zebra TLP 2844 printer?

How do I adjust alignment settings on a zebra TLP 2844 printer?

I have a zebra TLP 2844 printer for printing bar code labels. I use a program called commander NE for making the labels but they always turn out cut off a little to the left. How can I fix this?

Tags: , , , , ,

Under Forum

1 Comment for How do I adjust alignment settings on a zebra TLP 2844 printer?

  • 1. Denver Al  |  November 16th, 2010 at 10:19 pm

    I’m not familiar with the software you’re using, but most likely you need to adjust the label margins or reposition the label data in the program to adjust where it prints.

    Also, make sure the labels are loaded correctly within the printer to avoid them being off to one side that may be causing the alignment issue, I’m sure you’ve already checked that, but just making sure.

    You might try Zebra’s online or phone technical support. You can reach either from this link:
    zebra.com/id/zebra/na/en/index/products/printers/desktop/tlp2844.html

    You might also try the setup utilities that you can access with this link:
    zebra.com/id/zebra/na/en/index/products/printers/desktop/tlp2844.4.tabs.html
    that may allow you to adjust the printer’s internal alignment options to adjust the label position regardless of the software.

    Best of luck.

Leave a Comment for How do I adjust alignment settings on a zebra TLP 2844 printer?

You must be logged in to post a comment.

Trackback this post  |  Subscribe to the comments via RSS Feed

Categories