1 Comment for My Zebra LP2844 thermal printer for labels is giving me a spooling error. How do I fix the issue?
1.
Richard J | November 13th, 2010 at 8:21 am
Go to Start / Run and type in “services.msc” without quotation marks, then press Enter or click OK.
In the window that opens (Services) look for “Print Spooler” on the right
Right-click “Print Spooler” and select “Properties”.
Click on the “Recovery” tab and change all 3 drop-down boxes to “Restart The Service”.
Make sure the 2 text boxes underneath say “1″ in them.
Click Ok until you are back at the Services window, close it and you’re good to go.
Go back into the properties of the “Print Spooler” tab and be sure to click Start to restart the Print Spooler service and it will restart the service immediately.
The Print spooler depends on the Remote Procedure Call (RPC) service. Is this service disabled? Go to services.msc look for RPC. Check state: Automatic
Leave a Comment for My Zebra LP2844 thermal printer for labels is giving me a spooling error. How do I fix the issue?
1 Comment for My Zebra LP2844 thermal printer for labels is giving me a spooling error. How do I fix the issue?
1. Richard J | November 13th, 2010 at 8:21 am
Go to Start / Run and type in “services.msc” without quotation marks, then press Enter or click OK.
In the window that opens (Services) look for “Print Spooler” on the right
Right-click “Print Spooler” and select “Properties”.
Click on the “Recovery” tab and change all 3 drop-down boxes to “Restart The Service”.
Make sure the 2 text boxes underneath say “1″ in them.
Click Ok until you are back at the Services window, close it and you’re good to go.
Go back into the properties of the “Print Spooler” tab and be sure to click Start to restart the Print Spooler service and it will restart the service immediately.
The Print spooler depends on the Remote Procedure Call (RPC) service. Is this service disabled? Go to services.msc look for RPC. Check state: Automatic
Leave a Comment for My Zebra LP2844 thermal printer for labels is giving me a spooling error. How do I fix the issue?
You must be logged in to post a comment.
Trackback this post | Subscribe to the comments via RSS Feed